Description
Drop it in. Shoot it. That’s the whole install.
“Drop-in” gets printed on a lot of parts that arrive needing an evening with a stone before they’ll run. This one doesn’t. The M&P 2.0 Active Reset Device is held to tolerance where it matters, so there’s nothing left for you to correct — no polishing, no fitting, no filing, no tuning.
Heat-treated steel, QPQ coated. The heat treat puts the hardness through the part instead of on top of it, and the QPQ leaves a slick, corrosion-resistant surface that is part of the steel rather than a layer sitting on it — nothing to flake, nothing to wear through, nothing that changes dimension after a few thousand cycles. What you measure out of the bag is what it stays.
Fitment
Works in: M&P® 2.0 in 9mm, 10mm, .40 and .45 — Full Size, Compact, Subcompact, Metal, Performance Center and thumb safety variants.
Will not work in: M&P® 1.0, Shield, SD, FPC or Bodyguard models.
Will not work with: the Apex Forward Set Sear Actuator.
Specs
- Heat-treated steel
- QPQ coated
- True drop-in — no fitting, polishing or modification
Legal responsibility
It is the buyer’s responsibility to verify that this component is legal to own, install, and use in their jurisdiction. Active reset and similar rapid-cycling trigger systems have been the subject of ongoing federal and state legal action; the regulatory status has shifted multiple times in recent years and continues to evolve. Several states restrict or prohibit these systems outright.
VoidSpec does not provide legal advice. If there is any doubt about whether this part is appropriate for your jurisdiction or your specific situation, consult a firearms attorney in your state before purchasing.